Table of Contents
Advertisement
IF...
•
no message is recorded while the recording time passes, any
previously recorded message will be erased.
At the end of the recording, the TAD plays the message so that
you can check it immediately and the corresponding message
appears on the display.
The message recorded will be played in response to all incoming
calls.
When the TAD has finished playing the message, the machine
beeps and the next sub-menu appears on the display.
HOW TO RECORD MEMOS
The TAD can be used as an ordinary recorder to leave one or more memos which may even be played
from a remote location, when required. This section explains how to record memos.
Recording a memo
1.
Press >I/MEMO.
The display asks if you want to record memos.
2.
Press START and speak close to the microphone to ensure a
high quality recording.
The display shows the recording time in seconds. The message
LED blinks.
HOW TO PLAY AND ERASE INDIVIDUAL INCOMING MESSAGES OR MEMOS
If there are incoming messages and memos on the TAD, the message LED on the keypad of the fax
machine lights up if the messages have already been played back and blinks if there are new messages.
This section explains how to play back the messages and erase them individually if necessary.
v
The message LED is on
1.
Press >/II.
The TAD plays the recorded messages.
The message LED is on.
IF...
•
you want to skip from the current message to the next one, press >>I/MEMO
•
you want to skip from the current message to the previous one, press I<<
•
you want to stop playing the message, press >/II
•
you want to start playing the message again, press >/II
•
you want to erase a message, press CLEAR
•
you want to erase all the messages, see the section: How to erase all messages.
112
START/STOP
SYNTH. ANNOUNCE
FUNC/START/STOP
REC.MEMO MSG?
START/STOP
REC. MEMO:
THE TELEPHONE ANSWERING DEVICE
PLAYING
30
STOP
Advertisement
Table of Contents
