Installing The Ktm Powerpack - KTM Freeride E-XC NG 2018 Owner's Manual

17 KTM POWERPACK, BATTERY CHARGER
17.2
Note
Material damage Components damaged or destroyed by water or dirt.
–
Before installing the KTM PowerPack, check that the battery discharge plug on the electric motor and the bat-
tery discharge socket on the KTM PowerPack are clean.
–
Check the battery discharge plug form ring.
–
Clean the battery discharge plug and the battery discharge socket without using water or compressed air if the
battery discharge plug or the battery discharge socket is dirty.
–
After cleaning, spray silicone spray onto the battery discharge plug form ring.
108

Installing the KTM PowerPack

Caution
Risk of injury The KTM PowerPack is very heavy.
The KTM PowerPack must rest flush on the electric motor after installation.
–
Only lift the KTM PowerPack using the carry handle.
–
Make sure that nobody is pinched when the KTM PowerPack is removed or installed.
402145-12
Main work
–
Remove the covering cap. (
–
Check the battery discharge plug form ring. (
–
Position the KTM PowerPack
Lifting strap (70029022000)
The KTM PowerPack is resting flush on the electric motor.
Info
The KTM PowerPack is very heavy. A second person
can help with installation.
–
2
Tighten screws .
Guideline
KTM PowerPack
attachment
Finishing work
–
Lock the seat. ( p. 69)
p. 71)
p. 71)
1 in the vehicle.
M6 10 Nm (7.4 lbf ft)