Troubleshooting Of The Battery Charger - KTM Freeride E-XC NG 2018 Owner's Manual

23 TROUBLESHOOTING
23.2
Faults
Blink code 11 on battery
charger
Blink code 12 on battery
charger
Blink code 13 on battery
charger
Blink code 51 on battery
charger
Blink code 63 on battery
charger
Blink code 65 on battery
charger
130

Troubleshooting of the battery charger

402156-10
Possible cause
Fault in the charging cable
Fault in the charging cable
Fault in the charging cable
Overtemperature of the battery
charger
Fault in the supply voltage
Fault in the supply voltage
The faults are indicated by LED
the following blink codes are displayed on the charger and refer to
the charger itself.
Tip
The first step to take in case of any fault is to switch off
the battery charger, wait for 15 seconds, and then switch it
back on.
If a fault is not eliminated by the measures specified here,
or a blink code is not listed, an authorized KTM workshop
will be happy to help you.
Info
The pause between the signals of the 1st digit is 0.25 sec-
onds.
The pause between the 1st and 2nd digits is 1 second.
The pause between the signals of the 2nd digit is also
0.25 seconds.
The pause until the blink code repeats is 3 seconds.
Action
–
Check the charging plug and charging
cable for external damage and dirt and
reconnect.
–
Check the charging plug and charging
cable for external damage and dirt and
reconnect.
–
Check the charging plug and charging
cable for external damage and dirt and
reconnect.
–
Let the charger cool down.
–
Continue charging in a cooler location.
–
Use the Normal charging mode.
–
Choose a socket closer to the central
supply.
–
Use the Normal charging mode.
–
Choose a socket closer to the central
supply.
1 on the battery charger. All of