15 WHEELS, TIRES
94
Main work
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease the shaft seal rings
A
face
of the spacers.
Long-life grease (
–
Insert the spacers.
H00937-10
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Insert wheel spindle
–
Put the chain on.
C00737-10
–
Position chain adjuster
it yet.
–
Make sure that chain adjusters
adjusting screws
–
Check the chain tension. (
–
4
Tighten nut
Guideline
Nut, rear wheel spin-
dle
Info
The wide adjustment range of the chain adjusters
enables different secondary ratios with the same chain
length.
Chain adjusters
–
Operate the rear brake lever several times until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
C00707-11
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
1
and contact sur-
p. 139)
2
.
3
4
. Mount nut
, but do not tighten
3
are fitted correctly on
5
.
p. 73)
.
M20x1.5
80 Nm (59 lbf ft)
3
can be turned by 180°.
p. 108)
p. 69)
p. 57)