Installing The Ktm Powerpack - KTM Freeride E-SX 2015 Setup Instructions

4 SERVICE WORK
4.17

Installing the KTM PowerPack

Caution
Risk of injury The KTM PowerPack is very heavy.
The KTM PowerPack must rest flush on the electric motor after installation.
–
Only lift the KTM PowerPack using the carry handle.
–
Make sure that nobody is pinched when the KTM PowerPack is removed or installed.
Note
Material damage Components damaged or destroyed by water or dirt.
–
Before installing the KTM PowerPack, check that the battery discharge plug on the electric motor and the battery discharge socket
on the KTM PowerPack are clean.
–
Check the battery discharge plug form ring.
–
Clean the battery discharge plug and the battery discharge socket without using water or compressed air if the battery discharge
plug or the battery discharge socket is dirty.
–
After cleaning, spray silicone spray onto the battery discharge plug form ring.
Main work
–
Loosen screws
Note
Material damage Components damaged or destroyed by water or dirt.
–
Mount the covering cap if you have removed the KTM PowerPack.
–
Place the KTM PowerPack on a clean and dry surface.
–
Remove KTM PowerPack
PowerPack lifting strap (70029022000)
Info
The KTM PowerPack is very heavy. A second person can help with removal.
402145-11
(Option: HV 2 technical personnel)
–
Store the KTM PowerPack in a cabinet for hazardous goods.
Fire-resistant cabinet for hazardous goods (70029016000)
309887-10
Finishing work
–
Mount the covering cap.
Preparatory work
(Option: HV 2 technical personnel)
–
Perform an equipotential bonding check (KTM PowerPack installed).
( p. 25)
Main work
–
Remove the covering cap.
–
Check the battery discharge plug form ring.

.

.
( p. 12)
( p. 12)
( p. 13)
20