13 SERVICE WORK ON THE CHASSIS
13.16
13.17
68
Removing the shock absorber
A00188-10
Installing the shock absorber
A00188-11
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
p. 69)
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
–
Raise the motorcycle with a lift stand. (
Main work
–
Remove screw
1
.
–
2
Remove screw
and lower the rear wheel with the swing arm
as far as possible without blocking the rear wheel. Fix the rear
wheel in this position.
–
Remove screw
3
.
–
Push the splash protector
shock absorber.
Main work
–
1
Push splash protector
absorber.
–
Mount and tighten screw
Guideline
Screw, top
M12
shock absorber
–
Mount and tighten screw
Guideline
Screw, bottom
M12
shock absorber
Info
The heim joint for the shock absorber at the swingarm
is Teflon-coated. It must not be greased with grease,
nor with any other lubricants. Lubricants dissolve the
Teflon coating, thereby drastically reducing the service
life.
–
Mount and tighten screw
Guideline
Screw, upper
M10
subframe
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
p. 69)
p. 43)
p. 107)
p. 71)
p. 57)
4
to the side and remove the
to the side and position the shock
2
.
80 Nm (59 lbf ft)
Loctite
®
3
.
80 Nm (59 lbf ft)
Loctite
®
4
.
45 Nm (33.2 lbf ft)
Loctite
p. 57)
p. 108)
2701™
2701™
®
243™