Table of Contents
Advertisement
4
SERVICE WORK
4.17
Installing the KTM PowerPack
Caution
Risk of injury The KTM PowerPack is very heavy.
The KTM PowerPack must rest flush on the electric motor after installation.
–
Only lift the KTM PowerPack using the carry handle.
–
Make sure that nobody is pinched when the KTM PowerPack is removed or installed.
Note
Material damage Components damaged or destroyed by water or dirt.
–
Before installing the KTM PowerPack, check that the battery discharge plug on the electric motor and the battery discharge socket
on the KTM PowerPack are clean.
–
Check the battery discharge plug form ring.
–
Clean the battery discharge plug and the battery discharge socket without using water or compressed air if the battery discharge
plug or the battery discharge socket is dirty.
–
After cleaning, spray silicone spray onto the battery discharge plug form ring.
–
Store the KTM PowerPack in a cabinet for hazardous goods.
Fire-resistant cabinet for hazardous goods (70029016000)
309887-10
Finishing work
–
Mount the covering cap.
Preparatory work
–
Perform an equipotential bonding check (KTM PowerPack installed).
Main work
–
Remove the covering cap.
–
Check the battery discharge plug form ring.
–
Position the KTM PowerPack
PowerPack lifting strap (70029022000)
The KTM PowerPack is resting flush on the electric motor.
Info
The KTM PowerPack is very heavy. A second person can help with installa-
tion.
–
Tighten screws
Guideline
KTM PowerPack attachment
402145-12
Finishing work
–
Perform an equipotential bonding check (KTM PowerPack installed).
–
Lock the seat.
(
p. 10)
(
p. 10)
in the vehicle.
.
(
p. 12)
(
p. 11)
M6
10 Nm (7.4 lbf ft)
18
(
p. 22)
(
p. 22)
Advertisement
Table of Contents
