Installing The Powerpack Hv - KTM Freeride E-XC 2021 Owner's Manual

17.2

Installing the Powerpack HV

Caution
Risk of injury The Powerpack HV is very heavy.
The Powerpack HV must rest flush on the electric motor after installation.
–
Only lift the Powerpack HV by the carrying handle.
–
Make sure that nobody is pinched when the Powerpack HV is removed or installed.
Note
Material damage Components damaged or destroyed by water or dirt.
–
Before installing the Powerpack HV, check the discharge plug on the electric motor and the discharge socket
on the Powerpack HV for cleanliness.
–
Check the battery discharge plug form ring.
–
Clean the battery discharge plug and the battery discharge socket without using water or compressed air if the
battery discharge plug or the battery discharge socket is dirty.
–
After cleaning, spray silicone spray onto the battery discharge plug form ring.
POWERPACK HV, BATTERY CHARGER 17
Main work
–
Remove the protection cap. (
–
Check the battery discharge plug form ring. (
–
Position Powerpack HV
Lifting strap (70029022000)
The Powerpack HV rests flush with the electric motor.
Info
The Powerpack HV is very heavy. A second person can
help with installation.
–
Tighten screws
Guideline
Attaching Powerpack
HV
402145-12
Finishing work
–
Lock the seat. (
p. 71)
1
in the vehicle.
2
.
M6 10 Nm (7.4 lbf ft)
p. 69)
p. 71)
109