23 Troubleshooting; Vehicle Troubleshooting - KTM Freeride E-XC NG 2018 Owner's Manual

23 TROUBLESHOOTING

23.1
Faults
Blink code 11 on the vehicle
Blink code 13 on the vehicle
Blink code 22 on the vehicle
Blink code 23 on the vehicle
Blink code 24 on the vehicle
Blink code 31 on the vehicle
Blink code 33 on the vehicle
Blink code 34 on the vehicle
Blink code 41 on the vehicle
Blink code 42 on the vehicle
Blink code 43 on the vehicle
128

Vehicle troubleshooting

402136-10
Possible cause
KTM PowerPack is discharged
Fault during charging
Overtemperature of the control
unit
Overtemperature of the electric
motor
Overtemperature of the
KTM PowerPack
Fault in the CAN communica-
tion
Fault in the communication
with the KTM PowerPack
Fault in the communication
with the multifunction display
Fault in the throttle grip
Fault in the rotor position sen-
sor
Fault in the KTM PowerPack
The faults are indicated by the yellow electric motor indicator
1
lamp and by acoustic signals that sound at the same time.
Tip
The first step to take in case of any fault is to switch off
the vehicle at the main switch, wait for 15 seconds, and
then switch the vehicle back on.
If a fault is not eliminated by the measures specified here,
or a blink code is not listed, an authorized KTM workshop
will be happy to help you.
Info
The pause between the signals of the 1st digit is 0.25 sec-
onds.
The pause between the 1st and 2nd digits is 1 second.
The pause between the signals of the 2nd digit is also
0.25 seconds.
The pause until the blink code repeats is 3 seconds.
Action
–
Recharge the KTM PowerPack.
(
–
Use the charged KTM PowerPack.
–
Stop charging, switch off the main
switch, and restart charging.
–
Check the coolant level. (
–
Check the radiator for dirt.
–
Check the coolant level. (
–
Check the radiator for dirt.
–
Let the KTM PowerPack cool down.
–
Switch the main switch off and on.
–
Check the KTM PowerPack for correct
positioning.
–
Check the connection of the multifunc-
tion display for loose connectors.
–
Switch the main switch off and on.
–
Check the KTM PowerPack for correct
positioning.
–
Switch the main switch off and on.
–
Check the connection of the multifunc-
tion display for loose connectors.
–
Switch the main switch off and on.
–
Check the throttle grip for external
damage.
–
Switch the main switch off and on.
–
Switch the main switch off and on.
p. 111)
p. 118)
p. 118)