KTM Freeride E-XC NG 2018 Owner's Manual page 131

Faults
Blink code 44 on the vehicle
Blink code 45 on the vehicle
Blink code 46 on the vehicle
Blink code 51 on the vehicle
Blink code 52 on the vehicle
Blink code 53 on the vehicle
Blink code 54 on the vehicle
Speedometer values deleted
(time, stop watch, lap times)
The high beam, low beam,
parking light, tail light, and
license plate lamp are not
working
The speedometer, horn, brake
light, and turn signal are not
working
Possible cause
Fault in the 12 V supply
Fault in the electric motor
Fault in the onboard network
wiring harness or in a switch
Fault in the ECU
Fault in the moisture monitor
Fault in the KTM PowerPack
relay
Fault in the insulation monitor
The battery in the combination
instrument is discharged
Fuse 3 blown
Fuse 4 blown
TROUBLESHOOTING 23
Action
–
Charge the 12 V battery.
–
Install a new 12 V battery.
–
Switch the main switch off and on.
–
Switch the main switch off and on.
–
Check the onboard network wiring har-
ness and plug-in connections for exter-
nal damage.
–
Switch the main switch off and on.
–
Switch the main switch off and on.
–
Switch the main switch off and on.
–
Clean and dry the discharge plug and
discharge socket without compressed
air.
–
Change the combination instrument.
( p. 106)
–
Change the fuses of individual power
consumers. ( p. 100)
–
Change the fuses of individual power
consumers. ( p. 100)
( p. 99)
129