16.2
Installing the KTM PowerPack
Caution
Risk of injury The KTM PowerPack is very heavy.
The KTM PowerPack must rest flush on the electric motor after installation.
–
Only lift the KTM PowerPack using the carry handle.
–
Make sure that nobody is pinched when the KTM PowerPack is removed or installed.
Note
Material damage Components damaged or destroyed by water or dirt.
–
Before installing the KTM PowerPack, check that the battery discharge plug on the electric motor and the bat-
tery discharge socket on the KTM PowerPack are clean.
–
Check the battery discharge plug form ring.
–
Clean the battery discharge plug and the battery discharge socket without using water or compressed air if the
battery discharge plug or the battery discharge socket is dirty.
–
After cleaning, spray silicone spray onto the battery discharge plug form ring.
16 KTM POWERPACK, BATTERY CHARGER
Main work
–
Remove the covering cap. (
–
Check the battery discharge plug form ring. (
–
Position the KTM PowerPack
Lifting strap (70029022000)
The KTM PowerPack is resting flush on the electric motor.
Info
The KTM PowerPack is very heavy. A second person
can help with installation.
–
Tighten screws
Guideline
KTM PowerPack
attachment
402145-12
Finishing work
–
Lock the seat. (
p. 65)
1
in the vehicle.
2
.
M6
10 Nm (7.4 lbf ft)
p. 63)
p. 66)
103