Removing The Rear Wheel - KTM Freeride E-XC NG 2018 Owner's Manual

15 WHEELS, TIRES
15.3
92
H00935-10
A00133-10

Removing the rear wheel

Main work
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
of the spacers.
Long-life grease ( p. 139)
–
Insert the spacers.
–
Clean and grease the wheel spindle.
Long-life grease ( p. 139)
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
–
Operate the front brake lever several times until the brake lin-
ings are in contact with the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
3
Tighten screws .
Guideline
Screw, fork stub
Finishing work
–
Install the KTM PowerPack. (
–
Lock the seat. ( p. 69)
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. ( p. 69)
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
–
Raise the motorcycle with a lift stand. (
1 and contact surface
2
.
M20x1.5 35 Nm (25.8 lbf ft)
p. 57)
M8 15 Nm (11.1 lbf ft)
p. 108)
p. 43)
p. 107)
p. 71)
p. 57)
A