Controller Data Read - Omron SYSMAC CS1W-RPT01 Operation Manual

Commands and Responses for Controller Link Units
Response Block
6-5-4

CONTROLLER DATA READ

Command Block
Response Block
Parameters
04 02
Command Response
code code
The DATA LINK STOP command can be received only while the data links are
active. An error will occur if this command is sent at any other time.
This command can be received by any node that is participating in the data
link.
Reads the Controller Link Unit's model, version, and node address data.
05 01
Command
code
For C200HX/HG/HE, CVM1, and CV-series PLCs
05 01
Command Response
code code
For CS/CJ-series and CQM1H-series PLCs
05 01
Command Response
code code
Model, Version (response): The Controller Link Unit's model and version are
returned as shown below, each 20 characters in ASCII code. If fewer than 20
bytes of data are used, 20 (Hex) (i.e., spaces) will be returned for the remain-
ing bytes. In the version numbers shown below, the spaces are represented
by boxes (@).
Model
Example for CJ-series PLC Units:CJ1W-CLK21-V1@@@@@@@@
Version
PLCs other than CJ-series PLCs: V1.00@V1.00@@@@@@@@@
The first version number represents the Communications Controller version
number, and the second represents the Unit version number.
CJ-series PLCs: V2.00@V2.00@V2.00@@@
The first version number represents the data link layer Communications Con-
troller version number, the second represents the network layer Communica-
tions Controller version number, and the third represents the Unit version
number.
20 bytes 20 bytes
Model Version
Reserved for system
20 bytes 20 bytes
Model Version
Wired/
Optical
Section 6-5
00
Node address
Network
Node Unit
address
address address
205