Omron SYSMAC CS1W-RPT01 Operation Manual page 322

Status Area and Troubleshooting
Network Participation Status: AR 08, AR 09, AR 12, AR 13
Communications Controller Hardware Error, EEPROM Error: AR 11, AR 15
Service Time: AR 16, AR 17
Operating Level Connection Status, Inconsistent Network Parameters: AR 24
Polling Node Address, Startup Node Address: SR 238, SR 242
Data Link Status: SR 239
to SR 241, SR 243 to
SR 245
Operating level 0 Operating level 1
AR 08 AR 12
AR 09 AR 13
Operating level 0 Operating level 1
AR 11 AR 15
Operating level 0 Operating level 1
AR 16 AR 17
Operating level 0 Operating level 1
SR 238 SR 242
When the data link status stored in the start word for the manual setting data
link table or automatic setting data link parameters is not set or is set to 0, the
data link status of only node addresses 1 to 6 will be displayed in the following
area.
The numbers in the squares indicate node addresses.
The corresponding node participation status is as follows:
0: Not part of network
1: Part of network
1: Communications controller hardware error
1: EEPROM error
The service time for each PLC cycle is calculated by the PLC
and displayed in 0.1-ms units in 4-digit BCD.
Operating level 1
1: Network parameters do not match
Operating level 0
Operating level 1
1: Connecting to the operating level
Operating level 0
Polling node address
Each node address is displayed in 2-digit BCD.
Section 9-2
Startup node address
297