Omron SYSMAC CS1W-RPT01 Operation Manual page 59

Data Links Procedures
2-1 Data Links Procedures
2-1-1 Manually Setting Data Links
1,2,3...
34
When the data link mode is set for manual data link table creation, the data
link tables can be input using the Controller Link Support Software or CX-Pro-
grammer. Use the following procedure.
1. Install and wire the Units.
Contents
a. Mount the Units to
the PLCs.
b. Wire the Network.
2. Prepare for communications.
Contents
a. Set the unit num-
ber.
b. Set the node
address.
c. Set the baud rate.
d. Set the operating
level.
e. Set the terminal
resistance
3. Turn ON the power to the PLC.
Contents
Turn ON the power to
the PLC.
4. Connect the Programming Device.
Contents
Connect the Program-
ming Console or Con-
troller Link Support
Software.
5. Create I/O tables.
Contents
Input the I/O tables.
Method
--- All nodes
--- All nodes
Method
Use the front rotary CS/CJ-series, CVM1,
switches. and CV-series PLCs
only
Use the front rotary All nodes
switches.
Use the DIP switch. All nodes
Use the DIP switch. C200HX/HG/HE PLCs
only
Use the front switch All nodes
for CVM1, CV-series,
End nodes on the net-
CS/CJ-series, and
work: ON
CQM1H-series PLCs
All other nodes: OFF
or the bottom switch
for C200HX/HG/HE
PLCs.
Method
--- All nodes
Method
Use the special con- CS/CJ-series, CVM1,
nection cable. and CV-series PLCs
Method
Use the Support Soft- CS/CJ-series, CVM1,
ware or Programming and CV-series PLCs
Console. only
Section 2-1
Nodes Page
61
68
Nodes Page
100
96,100
97, 101
97
98, 101
Nodes Page
---
Nodes Page
23
Nodes Page
---