Omron SYSMAC CS1W-RPT01 Operation Manual page 220

Using the Message Service
C200HX/HG/HE and
CQM1H-series PLC
Response Codes
CS/CJ-series, CVM1, and
CV-series Response
Codes
The results of executing SEND and RECV instructions are reflected as shown
in the following table.
Code Contents
00 (Hex) Normal end
01 (Hex) Parameter error
02 (Hex) Transmission impossible
03 (Hex) Destination node error
04 (Hex) Destination node busy
error
05 (Hex) Response timeout
06 (Hex) Response error
07 (Hex) Communications control-
ler error
08 (Hex) Setting error
09 (Hex) CPU Unit error
10 (Hex) Routing error
11 (Hex) Relay error
12 (Hex) Source node busy error
The results of executing SEND, RECV, and CMND instructions are reflected
as one word (two bytes) of data. Instruction response codes are the same as
FINS command response codes. Response code bits 08 to 15 correspond to
the first byte of the response code, and response code bits 00 to 07 corre-
spond to the second byte of the response code. For details, refer to 6-7
Response Codes.
Meaning
Data transfer was completed successfully.
SEND/RECV instruction operands are not
within specified ranges.
The source node is not in the network or
the Unit was reset during execution of the
instruction.
The destination node is not in the network.
The destination node is busy and cannot
receive the command.
A response was not received within the
time limit.
The response received from the destina-
tion node was incorrect.
An error occurred in the communications
controller.
The destination node address was set
incorrectly.
A CPU Unit error occurred in the PLC of
the destination node.
Command could not be sent because of
incorrect routing.
Command did not reach the destination
node because of an error at the relay sta-
tion.
The source node is busy and cannot send
the command.
Section 6-3
195