Data Link Stop; Controller Data Read - Omron SYSMAC 3G8F7-CLK12-E Operation Manual

Commands and Responses for the Support Board

6-3-3 DATA LINK STOP

Command Block
Response Block

6-3-4 CONTROLLER DATA READ

Command Block
Response Block
05 01
Command
code
Parameters
84
Stops the Controller Link Network data links.
04 02
Command
code
04 02
Command Response
code code
The DATA LINK STOP command can be received only while the data links is ac-
tive. An error will occur if this command is sent at any other time.
This command can be received by any node that is participating in the data link.
Reads the Controller Link Support Board's model, version, node address, unit
address, connection type, and network address data.
05 01
Command
code
20 bytes
Response Model
code
Model, version (response): The Controller Link Unit's model and version are
returned as shown below, each 20 characters in ASCII code. If fewer than 20
bytes of data are used, 20 (Hex) (i.e., spaces) will be returned for the remaining
bytes. In the version numbers shown below, the spaces are represented by
boxes (j).
Model
3G8F7-CLK21-Ejjjjjjjjj (Wired)
3G8F7-CLK12-Ejjjjjjjjj (Optical Ring, H-PCF cable)
3G8F7-CLK52-Ejjjjjjjjj (Optical Ring, GI cable)
Version
The first "V1.01" represents the Support Board version number, and the second
represents the Communications Controller version number.
20 bytes 00
Version
Reserved Node
Wired/
for system address
Optical
V1.01jV2.03jjjjjjjjj
Section
Network
address
Unit
address
6-3