Omron SYSMAC CS1W-RPT01 Operation Manual page 338

Error Log
Error Contents
code
0101 Transmission failed; local node
Hex not in Network
0103 Transmission failed; retry count
Hex exceeded
0104 Transmission failed; maximum
Hex number of frames exceeded.
0105 Transmission failed; node
Hex address incorrect
0106 Transmission failed; redundant
Hex node address
0107 Transmission failed; destination
Hex node not in Network
0108 Transmission failed; specified
Hex Unit does not exist
Detail code
1st byte 2nd byte
Command block
Bits 0 to 7:
Source node address
Bits 8 to 14:
Source Network
address
Bit 15:
OFF
Response block
Bits 0 to 7:
Destination node
address
Bits 8 to 14:
Destination Network
address
Bit 15:
ON
(1st byte: bits 8 to 15;
2nd byte, bits 0 to 7)
Correction Written to
EEPROM
Refer to page 274 No
Troubleshooting
Using Indicators and
place the local node
into Network.
Using the Controller No
Link Support Soft-
ware or FINS
commands, run
echoback test and
check operating envi-
ronment if errors
occur.
Reduce the number No
of events per com-
munications cycle or
increase the maxi-
mum number of
network parameter
frames.
Refer to 4-2 CJ- No
series Controller Link
Units or 4-4 CVM1
and CV-series Con-
troller Link Units and
check node address
settings to be sure
they are within range
and unique.
Correct node No
addresses so that
they are unique
within the same
Network.
Refer to 9-1 Trouble- No
shooting Using Indi-
cators and place
destination node into
Network.
Refer to 4-4 CVM1 No
and CV-series Con-
troller Link Units and
check unit address
and unit number of
destination.
Section 9-3
Applicable
PLC
All
All
All
All
All
All
All
313