Connecting Power - Enterasys Matrix E1 1H582-25 Installation Manual

Installing the Device
3.7.4

Connecting Power

NOTE: The two power supplies in the device have automatic voltage sensing that
allows connection to power sources ranging from 100–125 Vac, 2.5 A or 200–240 Vac,
1.25 A, 50/60 Hz.
To connect the device to the power sources, refer to
1. Plug a power cord
capabilities, each power cord must be plugged into a separate dedicated ac outlet
2. Plug the other end of each power cord
Figure 3-11.
.
NOTE: To take advantage of the load sharing and redundancy capabilities, each power
cord must be plugged into a separate dedicated ac outlet.
Figure 3-11 1H582-51 Rear View
AC Power Cords
AC Power Receptacles
3-20 Hardware Installation
into each switch ac power receptacle
AC Power Outlets. Each outlet is on a separate circuit.
Figure 3-11
. To take advantage of redundancy
into a dedicated grounded ac outlet
Á
À
Â
and proceed as follows:
as shown in
.