Setting The Mode Switches - Enterasys Matrix E1 1H582-25 Installation Manual

Setting the Mode Switches

4. Remove the top cover
switches, proceed to
To reinstall the chassis cover, perform the removal procedures in reverse.
B.3 SETTING THE MODE SWITCHES
Figure B-2 shows the location of the mode switches and the switch settings for normal operation.
These switches are set at the factory and rarely need to be changed.
Switch definitions and positions are as follows:
•
Switches 1 through 6 – Reserved for future use.
•
Switch 7 – Clear NVRAM. Changing the position of this switch resets NVRAM on the next
power-up of the device. All user-entered parameters, such as the IP address, device names, etc.,
are reset to the factory default settings. Once the 1H582-xx resets, you can either use the factory
default settings or reenter your own parameters.
•
Switch 8 – Reset Password/Community Names. Changing the position of this switch clears
user-entered passwords stored in NVRAM, and restores the factory default passwords on the
next power-up of the device. Once the 1H582-xx resets, you can either use the factory default
settings or reenter your own passwords.
NOTE: Do not change the position of switch 8 unless it is necessary to reset the module
super-user configured passwords to their factory default settings.
B-4 Optional Installations and Mode Switch Bank Settings
by lifting it straight up and off the chassis . If you are setting the mode
Section B.3. If you are replacing a SIMM, proceed to Section B.4.