Installing An Ethernet Expansion Module - Enterasys Matrix E1 1H582-25 Installation Manual

Figure 3-1 Removing the Front Panel Coverplate
À
Ã
Â
Á
1H582-51 shown
Coverplate Captive Screws (2)
3.4.2

Installing an Ethernet Expansion Module

CAUTION: The expansion modules are NOT hot-swappable. The switch must be
powered down before the expansion modules are installed or removed. Hot-swapping
the expansion modules while the switch is powered on could cause the device to stop
forwarding frames.
Refer to Figure 3-2 and proceed as follows:
1. Pull the two Ethernet expansion module levers
CAUTION: If the expansion module does not insert smoothly when performing steps 2
or 3, do not force into place. Remove the expansion module and repeat the steps.
2. Align the Ethernet expansion module
the module into the slot until the levers
3. Rotate levers back to their center positions to fully seat the module rear connectors
4. Tighten the two captive screws
panel .
Installing an Optional Ethernet Expansion Module
Á
Coverplate
Front Panel
with the guides
just begin to move back towards each other.
to secure the Ethernet expansion module
outward to their maximum travel.
inside the option slot
Hardware Installation
, and push
.
to the device front
3-5