Enterasys Matrix E1 1H582-25 Installation Manual page 40

Installing Optional GBICs
Figure 3-5 GBIC Metal Locking Bar Positions
Â
GBIC
Top of GBIC
Metal Locking Bar (up position, unlocked)
Network Port
1G-2GBIC (Ethernet Expansion Module)
6. Once the GBIC 20-pin connector
GBIC metal locking bar until it clicks into place as shown in View B. Do NOT force the locking
bar into the locked position. If there is significant resistance while attempting to close the
locking bar, remove the GBIC. Inspect it for any problems with the connectors. If there are any
problems, contact Enterasys Networks for technical support (refer to
Section 1.4). If there are no problems, re-insert the GBIC carefully, and firmly seat it in the port
slot connector.
3-12 Hardware Installation
À
Á
È
has been firmly seated into the port slot, push down on the
Ç
Ä
20-Pin Connector (insertion side)
Alignment Slots
Port Slot
Metal Locking Bar (down position, locked)
Å
Æ
Ã
"Getting Help" in