Powering Up The Ssa; Connecting Power To The Ssa - Enterasys SSA-T1068-0652 Hardware Installation Manual

Powering Up the SSA

4. If you are installing a second power supply, remove the coverplate from the right power
supply bay by unscrewing the screws that attach the coverplate to the SSA.
Keep the coverplate in the event you need to remove the power supply.
5. Repeat steps 2–3 to install the power supply in the right power supply bay.
6. Tighten the captive screws of the power supplies.
Powering Up the SSA
To connect the SSA to the power sources:
1. Plug a power cord into each power supply's AC power receptacle.
2. Plug the cord into a dedicated grounded AC outlet as shown in Figure
To take advantage of redundancy capabilities, plug each power cord into a separate dedicated
AC outlet.
3. (Optional) Secure each power cord to the SSA by tying the power cords to the plastic brackets,
adjacent to the power supply bays, with customer‐supplied zip ties.
Figure 2-11
1 Plastic brackets for securing AC power cords to the SSA
The PWR LED, located on the front panel, turns ON (green) and the CPU LED turns red until the
SSA completes its initialization.
When the initialization process is successful, the CPU LED turns green. If the CPU LED does not
turn green, refer to Chapter
2-14 Installation

Connecting Power to the SSA

3, Troubleshooting, for troubleshooting information.
2‐11.