Enterasys Matrix E1 1H582-25 Installation Manual page 81

ELECTRICAL HAZARD: TURN OFF THE 1H582-25/1H582-51 BY UNPLUGGING
THE POWER CORD FROM THE REAR OF THE CHASSIS.
AM HINTEN DES 1H582-25/1H582-51 STECHEI ABZIEHEN UM AUS ZU SCHALTEN.
APAGUE EL 1H582-25/1H582-51 DESENCHUFE EL CABLE DE LA UNIDAD.
TIP: Before performing step b, mark the cables connected to the 1H582-51 according to
their associated port numbers. This is recommended for ease of reinstallation.
b. Disconnect all network cables attached to the 1H582-xx.
2. If the 1H582-xx is rack mounted, remove it from the rack (refer to
3. Use a Phillips screwdriver to remove the 12 screws
(See Figure B-1.)
Figure B-1 Removing the Chassis Cover
Â
12 Cover Screws
À
Coverplate
Optional Installations and Mode Switch Bank Settings
Removing the Chassis Cover
Chapter
attaching the cover
1H582-51 Device (shown)
3).
to the chassis .
Á
B-3