Installing The Locking Bar Gbic - Enterasys Matrix E1 1H582-25 Installation Manual

3.5.2.1

Installing the Locking Bar GBIC

Prepare and install the GBIC into the 1G-2GBIC as follows:
Preparation
Before installing the GBIC, proceed as follows:
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the GBIC from the antistatic packaging.
2. Remove the GBIC from the packaging.
3. If there is a protective dust cover on the port, remove it from the GBIC.
Installation
To install the GBIC, refer to
1. Hold the GBIC
2. Lift the metal locking bar
the GBIC clips.
3. Hold the GBIC
connector should be facing towards the empty port slot
adjacent to the door hinge of the port slot door.
4. Align the GBIC alignment slots
into the slot.
CAUTION: If, in the following step, the GBIC does not insert easily and stops about one
quarter of the way into the slot, do not try to push it in any further. Remove and check
the orientation against
20-pin port engages with the connector in the port slot.
5. Push the GBIC
slot .
Figure 3-5 (Views A and B) and proceed as follows:
with the top of the body
upwards as far as it will go. See
with the network port
with the card guides inside the port slot
Figure 3-5. Try again to push the GBIC into the slot until the
back until the 20-pin connector port
facing up, as shown in View A.
Figure
facing away from the 1G-2GBIC
. The top of the GBIC
engages with the connector in the port
Installing Optional GBICs
3-5, View A. This unlocks
. The 20-pin
. The door folds up
Hardware Installation
must be
3-11