Enterasys Matrix E1 1H582-25 Installation Manual page 42

Installing Optional Mini-GBICs
To prepare and install a Mini-GBIC into the 1G-2MGBIC, proceed as follows:
Preparation
Before installing the Mini-GBIC, proceed as follows:
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the Mini-GBIC from the antistatic packaging.
2. Remove the Mini-GBIC from the packaging.
3. If there is a protective dust cover (see
at this time.
Installation
To install a Mini-GBIC, refer to
1. Hold the Mini-GBIC
1G-2MGBIC port slot
2. Carefully align the Mini-GBIC
3. Push the Mini-GBIC
Figure 3-6 Mini-GBIC Installation
Mini-GBIC
,
Mini-GBIC Top Side
7-Pin Edge Connector (insertion side)
3-14 Hardware Installation
Figure
Figure 3-6 and proceed as follows:
with its top side facing up and its 7-pin edge connector
as shown in Figure
with the 1G-2MGBIC port slot
into the port slot
Á
À
Ä
Å
3-6, ) on the Mini-GBIC port, do not remove it
3-6.
until the Mini-GBIC "clicks" and locks into place.
Ã
Â
1G-2MGBIC Port Slot
,
Mini-GBIC Protective Dust Cover
Locking Tab
facing the
.