3.10 Completing The Installation - Enterasys Matrix E1 1H582-25 Installation Manual

RJ45
Pin
1
2
4
5
6
8

3.10 COMPLETING THE INSTALLATION

After installing the 1H582-25 or 1H582-51 and making the connections to the network, secure the
cables by running the cables along the strain-relief bracket and tying them to the strain-relief
bracket using cable ties.
Initial Logon to Device Management
You can now logon to the 1H582-25 or 1H582-51 via the console port and configure it using the
command line interface (CLI). To initially access device management from your local pc, terminal,
or modem connection, proceed as follows:
1. Enter rw (Read-Write) for Username.
2. At the Password prompt, press ENTER (RETURN).
For details on how to configure the 1H582-51 using the command line interface, refer to the
Matrix E1 (1G582-09 and 1H582-51) Configuration Guide. The CLI commands enable you to
initially set up and perform more involved switch management configurations.
After the initial configuration, you can also use WebView (Enterasys Networks' embedded web
server) for configuration and management tasks, refer to the Matrix E1 (1G582-09 and 1H582-51)
WebView User's Guide.
Modem Port Adapter Wiring and Signal Diagram
Conductor
Blue
Orange
Red
Green
Yellow
Gray
DB25
Pin Signal
2 Transmit (TX)
8 Data Carrier Detect (DCD)
3 Receive
7 Ground (GRD)
20 Data Terminal Ready (DTR)
22 Ring Indicator
Completing the Installation
Hardware Installation 3-35