Rack Mounting The Device - Enterasys Matrix E1 1H582-25 Installation Manual

Installing the Device
2. Place the device upside down (as shown in
strain-relief bracket
Figure 3-8 Attaching the Strain-Relief Bracket
Strain-Relief Bracket
3.7.3

Rack Mounting the Device

Proceed as follows to install the device into a 19-inch rack:
1. Attach the rackmount brackets
M4 x 6 mm flathead screws
3-18 Hardware Installation
to the bottom of the device using the four M4 x 6 mm pan-head screws
to the device, as shown in
in the rackmount kit.
Figure 3-8) on a clean flat surface. Then attach the
Á
À
M4 x 6 mm Pan-Head Screws
Figure 3-9, using the eight
.