SIMM Replacement Procedure
2. Pivot the SIMM
notches
and the connector clips lock the SIMM into place.
Figure B-5 Installing the DRAM
Ä
SIMM Alignment Notch
SIMM
3. Reconnect the device to the network as follows:
a. Reinstall the device into the rack if necessary.
b. Reinstall the top cover.
c. Reconnect the network cables to the device.
d. Reconnect both power cords from the rear of the chassis to the ac power outlets.
This completes the replacement of the DRAM SIMM.
B-8
Optional Installations and Mode Switch Bank Settings
downward so the connector clips
Ã
Á
Connector Fingers
Connector Clips
align with the two SIMM alignment
Â
À
Ä
SIMM Alignment Notches (2)
Ã