Connecting Ac And Poe Power; Switch Rear View - Enterasys SecureStack C2 C2G124-48P Hardware Installation Manual

Connecting AC and PoE Power

AC Power
To connect the switch to the power source, refer to Figure
1. Plug the power cord into the switch AC power connector.
2. Plug the other end of the power cord into a dedicated grounded AC outlet (not
shown). The type of power outlet and power cord are country dependent.
Figure 3-8
1 AC power cord
Note: The power supply in the switch has automatic voltage sensing that allows
connection to power sources ranging from 100 to 240 VAC.
Note: If you plan to connect all the switches quickly to allow automatic Manager selection,
wait until all switches are fully operational before proceeding to the next step.
If you plan to power up each switch and allow it to become fully operational before
applying power to the next switch, proceed to the next step.

Switch Rear View

Á
À
2 AC power connector

Connecting AC and PoE Power

3‐8 and proceed as follows:
Â
3 Connector for external redundant power supply
SecureStack C2 Installation Guide 3-15