Enterasys Matrix E1 1H582-25 Installation Manual page 69

Table 4-2 Troubleshooting Checklist (Continued)
Problem
Cannot navigate
beyond Startup
screen.
Cannot contact
the device
through in-band
management.
Possible Cause
Improper Community
Names Table.
IP address not assigned.
Port is disabled.
No link to device.
Recommended Action
Refer to the Matrix E1 (1G582-09 and
1H582-51) Configuration Guide for the
Community Names Table setup.
If the Community Names have been
forgotten, refer to Section B.3
instructions on how to set the mode switch to
reset the Community Names to their default
values.
Refer to the Matrix E1 (1G582-09 and
1H582-51) Configuration Guide for the IP
address assignment procedure.
Enable port. Refer to the Matrix E1
(1G582-09 and 1H582-51) Configuration
Guide for instructions to enable/disable
ports.
Verify that all network connections between
the network management station and the
device are valid and operating.
If the problem continues, contact
Enterasys Networks for technical support.
Troubleshooting Checklist
for
Troubleshooting 4-5