Installing an Optional Ethernet Expansion Module
Figure 3-2 Installing the Ethernet Expansion Module
Á
Å
À
Levers
Ethernet Expansion Module
Guides
Option Slot
This completes the Ethernet expansion module installation. If you installed an Ethernet expansion
module that accepts GBICs, proceed to
to
Section 3.7
to continue installing the device.
3.4.3
Removing the Ethernet Expansion Module
To remove the Ethernet expansion module, refer back to
CAUTION: The expansion modules are NOT hot-swappable. The switch must be
powered down before the expansion modules are installed or removed. Hot-swapping
the expansion modules while the switch is powered on could cause the device to stop
forwarding frames.
3-6
Hardware Installation
Æ
À
Rear Connectors
Captive Screws (2)
Front Panel
Section 3.5
for installation instructions. Otherwise, proceed
Â
Ä
Å
Figure 3-2
and proceed as follows:
Ã