Enterasys Matrix E1 1H582-25 Installation Manual page 59

2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB9 adapter (supplied
with the device).
3. Connect the RJ45-to-DB9 adapter to the communications port on the PC.
4. Turn on the PC and configure your VT emulation package with the following parameters:
When these parameters are set, the Startup screen will display. Proceed to
the installation.
Figure 3-20 Connecting an IBM PC or Compatible
À
PC
RJ45-to-DB9 PC Adapter
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Á
UTP Cable with RJ45 Connectors
RJ45 Console Port
Connecting to Console Port for Local Management
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Â
Section 3.10 to complete
Ã
Hardware Installation 3-31