Enterasys Matrix E1 1H582-25 Installation Manual page 55

2. Refer to Figure 3-18
GPIM-01, GPIM-08, or GPIM-09
application of the GBIC. Refer to
be used in the installation.
Figure 3-18 Fiber GBIC Connections
SC Cable Connector
Latch Keys (bottom of SC connector)
GPIM-01, GPIM-08, or GPIM-09
3. At the other end of the fiber optic cable, attach the SC connector to the other device. Verify that
a link exists by checking that the Link LED
on the LEDs. If the Link LED is OFF and the RX/TX LED
the following steps until it is ON:
a. Check that the device at the other end of the link has power turned on and is Gigabit Ethernet
compatible.
b. Verify proper crossover of fiber strands between the port on the device and the fiber optic
device at the other end of the fiber optic link segment.
c. Verify that the fiber optic cable meets the specifications outlined in
installed GBIC.
and insert one end of the SC cable connector
. Ensure that the appropriate cable is used for the
Appendix C
Â
Á
for the appropriate GBIC and fiber optic cable to
Ã
Ä
À
Link LED
Receive/Transmit (RX/TX) LED
is ON (solid green). Refer to
is not blinking amber, perform
Connecting to the Network
, key side down
Chapter 4 for details
Appendix C for the
Hardware Installation
, into the
3-27