Unpacking The Dfe Module; Installing Optional Network Expansion Module (Nem); 7H4284-49 Dfe Module - Enterasys Matrix 7H4284-49 Hardware Installation Manual

Unpacking the DFE module

3.1 UNPACKING THE DFE MODULE
Unpack the DFE module as follows:
1. Open the box and remove the packing material protecting the DFE module.
2. Verify the contents of the carton as listed in
Table 3-1 Contents of DFE Module Carton
Item

7H4284-49 DFE module

This Installation Guide
Customer Release Notes
3. Remove the tape seal on the non-conductive bag to remove the DFE module.
4. Perform a visual inspection of the DFE module for any signs of physical damage. Contact
Enterasys Networks if there are any signs of damage. Refer to
details.
3.2

INSTALLING OPTIONAL NETWORK EXPANSION MODULE (NEM)

Note: Install any optional equipment before proceeding to
explanation of the rules to install different modules in a Matrix E7 chassis.
Refer to your release notes or the Enterasys Networks web site for the latest available network
expansion modules.
A Phillips screwdriver is required to install an optional NEM into the 7H4284-49 DFE module.
Installing a NEM involves
• removing the coverplate from the DFE module and
• attaching the NEM to the DFE module.
Refer to the installation instuctions shipped with the NEM for details.
3-2 Installation
Table 3-1.
"Getting Help"
Quantity
1
1
1
on page xviii for
Section 3.3 for an