Unpacking the DFE-Platinum Module
UNPACKING THE DFE-PLATINUM MODULE
Unpack the DFE‐Platinum module as follows:
1.
Open the box and remove the packing material protecting the DFE‐Platinum module.
2.
Verify the contents of the carton as listed in Table
Table 3-1 Contents of DFE-Platinum Module Carton
Item
DFE-Platinum module (7G4202-60
Installation Guide
Customer Release Notes
3.
Remove the tape seal on the non‐conductive bag to remove the DFE‐Platinum
module.
4.
Perform a visual inspection of the DFE‐Platinum module for any signs of physical
damage. Contact Enterasys Networks if there are any signs of damage. Refer to
"Getting Help" on page xviii for details.
INSTALLING OPTIONAL NETWORK EXPANSION MODULE (NEM)
Refer to your release notes or to the Enterasys Networks web site for the latest available
network expansion modules.
A Phillips screwdriver is needed to install an optional NEM into the 7G4282‐41.
Installing a NEM involves
•
removing the coverplate from the DFE‐Platinum module, and
•
attaching the NEM to the DFE‐Platinum module.
Refer to the installation instructions shipped with the NEM for details.
3-2
Installation
Note: Install any optional equipment before proceeding to
Installation Rules"
on page 3-3 for an explanation of the rules to install different series
modules in a Matrix E7 chassis.
or
7G4282-41)
3‐1.
Quantity
"Backplane Connections and
1
1
1