3.4
INSTALLING AN OPTIONAL ETHERNET EXPANSION MODULE
Note: Install any optional equipment before proceeding to
Installing an Ethernet expansion module involves the following:
•
Removing the front panel coverplate
•
Installing the Ethernet expansion module
Caution: An antistatic wrist strap is required to perform the following procedures to minimize ESD
damage to the devices involved.
Precaución: Para minimizar los efectos de las descargas de electricidad estática, deberá utilizar
una pulsera antiestática al realizar los siguiente procedimientos.
3.4.1
Removing the Front Panel Coverplate
Refer to
Figure 3-1
1. Attach the antistatic wrist strap (refer to the instructions on the antistatic wrist strap package).
2. Place the 1G694-13
3. Loosen the two captive screws
4. Remove the coverplate
Figure 3-1 Removing the Front Panel Coverplate
➀
1G694-13
➁
Coverplate captive screws (2)
and proceed as follows:
➀
on an antistatic pad (not shown) on a sturdy flat surface.
➁
until the coverplate
➂
from the front panel
Installing an Optional Ethernet Expansion Module
(Section
3.4.1)
(Section
3.4.2)
➂
➃
. Save the coverplate for future use if necessary.
➂
Coverplate
➃
Front panel
Section
3.7.
is released from the front panel
À
Ã
Á
Hardware Installation
➃
.
Â
Á
3-3