Installation; Calibration - Sony MAS-A100 Manual

Connection check
If connected successfully, the sound captured by the MAS-A100 is now input to the
speech reinforcement system and remote conference system.
Use the test signal generator function of the MASM-1, and check that the test signal is
emitted from the loudspeakers with the appropriate volume.
Next, speak facing the MAS-A100 and check that there are no issues with the audio
input using the input level meter of the remote conference device.

7.6. Installation

Install the MAS-A100 and other devices according to the design.
For details about installing, refer to the MAS-A100 Operating Instructions.

7.7. Calibration

Refer to "Calibration preparation" (page 63) and check that the test signal is emitted
from the speech reinforcement loudspeakers with the appropriate volume. If required,
adjust the volume of the mixer or amplifier.
Perform calibration as described in "Calibrating" (page 64).
94