Sony MAS-A100 Manual page 100

F
Cannot connect with MAS-A100.
Is the MAS-A100 LED lamp
flashing red?
Is the MAS-A100 LED lamp lit
green, red, or amber?
Is network cable connected?
Is a PoE hub connected?
Is PoE hub turned on?
Is PoE power delivery
indicator lit on PoE hub?
No
Is a PoE-compatible network cable
(Cat 5e or higher) being used?
Is the power consumption of the
PoE devices connected to the PoE
hub less than the power that the
hub can supply?
Is PoE hub ground line
connected to building ground?
Is the PoE hub port power
delivery enabled?
Contact your local Sony dealer.
The MAS-A100 is in factory default state.
Yes Initialize the MAS-A100.
(See "5.2 MAS-A100 initial setup using
MASM-1" (page 49))
Yes
I (page 101)
Connect the network cable.
(Refer to the MAS-A100 Operating
No
Instructions)
Use a PoE hub.
No
(Refer to the MAS-A100 Operating
Instructions)
Turn on the PoE hub.
No
(Refer to the MAS-A100 Operating
Instructions)
Yes
P (page 102)
Use a PoE-compatible network cable.
No
(Refer to the MAS-A100 Operating
Instructions)
Remove some PoE devices to keep within
No
power supply limit of the hub.
(See "4.3 Network design" (page 23))
Connect the hub to ground (Earth).
No
(See "4.3 Network design" (page 23))
Configure the hub.
No
(See "4.3 Network design" (page 23))
100