Sony MAS-A100 Manual page 106

2
Sound not emitted from Main output
(speech reinforcement) only.
Is the MAS-A100 LED lamp lit
green?
Main output of MAS-A100 is
routed to Dante receiver device.
Noise gate of Main output is set to
[Off].
Contact your local Sony dealer.
If the MAS-A100 LED lamp is flashing red,
initialize the MAS-A100.
If lit amber, turn off [Mute] in MASM-1.
No
If lit red, cancel standby state in MASM-1.
(See "5.2 MAS-A100 initial setup using
MASM-1" (page 49))
(See "6.1 Monitor" (page 78))
Use Dante Controller to control Dante
No
routing.
(See "5.4 Routing of Dante audio" (page 59))
When the noise gate is set to
No
Low/Middle/High, no sound is output below
a certain audio input threshold.
(See "Noise gate (for Main)" (page 72))
106