Sony MAS-A100 Manual page 107

3
Volume of Main output (speech
reinforcement) is low.
Gain setting of Main output is
set to 0 dB ± 12 dB.
Gain limit lamps are not lit, or only
one is lit.
The calibration result is "Average"
or higher.
Contact your local Sony dealer.
Slowly increase the gain of the Main output
No
and check whether the sound gets louder.
The MAS-A100 and loudspeaker are too
close, or the amplifier gain is too high.
Move the loudspeakers away from the
MAS-A100, or turn down the volume of the
No
loudspeakers near the MAS-A100 and
calibrate again.
(See "Installation environment for speech
reinforcement" (page 19))
The volume of the loudspeaker is too low.
If the Gain setting of the MAS-A100 cannot
Yes
be adjusted, adjust the volume setting of
the amplifier, and perform calibration
again.
(See "Installation environment for speech
reinforcement" (page 19))
107