Routing Of Dante Audio - Sony MAS-A100 Manual

It can be configured using the following three methods according to the installation
environment.
Addresses
Obtain an IP Address
Automatically (default)
Manually configure an IP Address

5.4. Routing of Dante audio

Configure the routing of the audio signals between the Dante devices (register the
logical connection to the Dante devices).
This section describes routing the output of the MAS-A100 to a Dante receiver device
(digital mixer or Dante/Analog converter).
Routing is performed using Dante Controller installed on a PC connected to the same
segment (same layer 2 network) as the MAS-A100 units in a room where the
MAS-A100 units are installed.
[Default Dante ID] check
1. Open the [Settings] tab of MASM-1, and select any group in the left pane.
2. Select [System] from the drop-down menu in the right pane.
3. Check the MAS-A100 status using the status lamp.
Connected IP address setting
network
environment
Using DHCP DHCP automatically assigns the IP address of
Dante devices. Set the PC running Dante
Controller to obtain IP address from DHCP
automatically.
Without DHCP The IP addresses of Dante devices are
automatically assigned in the range of
169.254.0.0/16 by Auto IP. Set the IP
address of the PC running Dante Controller in
the range of 169.254.0.0/16 manually.
You can set the IP address of a Dante device
manually using [Device View] – [Network
Config] tab of Dante Controller. After
configuration, change the setting of the IP
address of the PC running Dante Controller so
that it is also on the same subnet.
59