Sony MAS-A100 Manual page 105

1
No sound emitted from Dante receiver device.
Is MAS-A100 and Dante
receiver device routing
configured in Dante Controller?
Is there only one Primary v1
Multicast master on the [Clock
Status] tab of Dante Controller?
Is the MAS-A100 LED lamp lit
green?
Contact your local Sony dealer.
Initialize and configure routing of MAS-A100
No
and Dante devices.
(See "5.4 Routing of Dante audio" (page 59))
Multicast is not switched correctly.
Use a Dante-compatible network switch
No
configured correctly.
(See "4.3 Network design" (page 23))
If the MAS-A100 LED lamp is flashing red,
initialize the MAS-A100.
If lit amber, turn off [Mute] in MASM-1.
No
If lit red, cancel standby state in MASM-1.
(See "5.2 MAS-A100 initial setup using
MASM-1" (page 49))
(See "6.1 Monitor" (page 78))
105