Figure 45. Removing the service access cover
1) Release the latch by pushing the release latch (A) in the direction shown.
2) Slide the cover (B) off the system unit. When the front of the service access cover has cleared
the upper frame ledge, lift the cover up and off the system unit.
d) Carefully tilt the stand-alone system from its vertical position to lay it in a horizontal position.
Position the system with the open service area up, and with a 3 cm (1.5") support (A) along its top
edge, as shown in Figure 46 on page 64.
The support (A) is used to prevent the plastic handle from being damaged.
Common procedures for installable features 63