Advertisement
For a stand-alone system, complete the following steps. Refer to Figure 24 on page 39.
Attention: Operating the system without the service access cover on for more than 10 minutes
when the system power is turned on might damage the system components.
a. Release the latch by pushing the release latch (A) in the direction shown.
b. Slide the cover (B) off the system unit. When the front of the service access cover has cleared the
upper frame ledge, lift the cover up and off the system unit.
Figure 24. Removing the service access cover
Installing the service access cover
Use this procedure to install the service access cover on an 5105-22E, IBM Power System L922
(9008-22L), IBM Power System S922 (9009-22A and 9009-22G), IBM Power System H922 (9223-22H),
IBM Power System H922S (9223-22S), IBM Power System S914 (9009-41A and 9009-41G), IBM Power
System S924 (9009-42A and 9009-42G), IBM Power System H924 (9223-42H), or IBM Power System
H924S (9223-42S) server.
Common procedures for installable features 39
Advertisement
