Advertisement
Figure 22. Removing the service access cover
Removing the service access cover from a rack-mounted 9009-41A, 9009-41G, 9009-42A, 9009-42G,
9223-42H, or 9223-42S system
Use this procedure to remove the service access cover from a rack-mounted IBM Power System S914
(9009-41A and 9009-41G), IBM Power System S924 (9009-42A and 9009-42G), IBM Power System
H924 (9223-42H), or IBM Power System H924S (9223-42S) server.
Before you begin
Attention: Operating the system without the service access cover on for more than 10 minutes
when the system power is turned on might damage the system components.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Remove the service access cover.
For a rack-mounted system, complete the following steps. Refer to Figure 23 on page 38.
Attention: Operating the system without the service access cover on for more than 10 minutes
when the system power is turned on might damage the system components.
Common procedures for installable features 37
Advertisement
