Installing the service access cover on a rack-mounted 9009-41A, 9009-41G, 9009-42A, 9009-42G,
9223-42H, or 9223-42S system
Use this procedure to install the service access cover on a rack-mounted IBM Power System S914
(9009-41A and 9009-41G), IBM Power System S924 (9009-42A and 9009-42G), IBM Power System
H924 (9223-42H), or IBM Power System H924S (9223-42S) server.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Replace the service access cover.
For a rack-mounted system, complete the following steps. Refer to Figure 26 on page 41.
a. Slide the cover (A) onto the system unit.
b. Close the release latch (B) by pushing it in the direction shown.
Figure 26. Installing the service access cover
Common procedures for installable features 41