Advertisement
The cover has indentations where you can hold it more easily. Use the alignment pin (B) to secure the
cover to the system as shown in Figure 13 on page 28. Push along the grill area above the fans to
secure the cover to the front.
Figure 13. Installing the front cover
Installing the front cover on a rack-mounted 9009-41A, 9009-41G, 9009-42A, 9009-42G, 9223-42H,
or 9223-42S system
Use this procedure to install the front cover on a rack-mounted IBM Power System S914 (9009-41A and
9009-41G), IBM Power System S924 (9009-42A and 9009-42G), IBM Power System H924 (9223-42H),
or IBM Power System H924S (9223-42S) server.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. For a rack-mounted system, gently push the front cover (A) in until the cover snaps into place.
The cover has indentations where you can hold it more easily. Use the alignment pins (B) to secure the
cover to the system as shown in Figure 14 on page 29.
28 Power Systems: Common procedures for installable features
Advertisement
