Advertisement
Installing the service access cover on a stand-alone 9009-41A or 9009-41G system
Use this procedure to install the service access cover on a stand-alone IBM Power System S914
(9009-41A or 9009-41G) server.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Replace the service access cover.
For a stand-alone system, complete the following steps. Refer to Figure 27 on page 42.
a. Slide the cover (B) on to the system unit as shown.
b. Close the latch release (A) by pushing it in the direction shown.
Figure 27. Installing the service access cover
Removing and replacing the air baffle
Use this procedure to remove and replace the air baffle in a 5105-22E, IBM Power System L922
(9008-22L), IBM Power System S922 (9009-22A and 9009-22G), IBM Power System H922 (9223-22H),
IBM Power System H922S (9223-22S), IBM Power System S914 (9009-41A and 9009-41G), IBM Power
System S924 (9009-42A and 9009-42G), IBM Power System H924 (9223-42H), or IBM Power System
H924S (9223-42S) server.
42 Power Systems: Common procedures for installable features
Advertisement
