Advertisement
a. Release the service cover latch by pushing the release latch (A) in the direction shown.
b. Slide the cover (B) off the system unit. When the front of the service access cover clears the upper
frame ledge, lift the cover up and off the system unit.
Figure 23. Removing the service access cover from a rack-mounted system
Removing the service access cover from a stand-alone 9009-41A or 9009-41G system
Use this procedure to remove the service access cover from a stand-alone IBM Power System S914
(9009-41A or 9009-41G) server.
Before you begin
Attention: The system must be powered off before removing the side cover.
Attention: Operating the system without the service access cover on for more than 10 minutes
when the system power is turned on might damage the system components.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Remove the service access cover.
38 Power Systems: Common procedures for installable features
Advertisement
